![]() ![]() Replace timing chain tensioner and O-Ring Muffler rear part was original and needed to be changed. #TENSR 800 MANUAL INSTALL#Remove and install new computer-major problem with Corollas 2000-2010Įngine light. The spark plugs were replaced. All of the motor mounts and transmission mounts needed to be changed, as well. Also, the valve cover gasket was leaking so that was replaced. Had to replace the radiator (small hole in it). Otherwise, replacing it using with a new part as recommended by the service bulletin would have cost $600 - $800. Taking the risk that the problem will occur again. Replaced the part with a similar salvaged ECM from ebay for $26 + Toyota OBDII cable to program the VIN into the unit. ![]() This is a common problem with 2005-2007 Toyota Corollas TSB TC015-07. #TENSR 800 MANUAL CODE#Replaced leaking valve cover and oil pan gasketsĮrror code P2716 - Pressure Control Solenoid, showed up due to bad ECM. A rubber gasket on the intake manifold was warn out or defective, requiring replacement of gasket. Minor oil leak near engine gasket replacement solved the issue.īrought the car in because of a warning light. The noise would go away for the rest of the day, but I went ahead and had the timing belt replaced. The car squealed moderately loudly for about 10 minutes after first starting up the car in the mornings. Intake manifold gasket leak triggering check engine light. Old gasket was worn and caused a vacuum leak.įuel System evaporative cannister was replaced Replace intake manifold gasket with a new one. Heat shield between exhaust and gas tank came loose. Resonator pipe separated from the muffler pipe. Replaced Gas Cap.Įxhaust pipe sheared at rear flange (muffler). Obtained Denso radiator off Amazon - very easy to remove and replace radiator. Took back to dealership for clutch replacement - about 24hour turnaround. Recently started slipping in 2nd gear also. $10 part, 1.5 hours labor.Ĭlutch had been slipping intermittently for about a year - mainly starting up steep grades. From internet research, replaced intake manifold gasket. Check engine light on, code said "engine running lean). Replaced it, engine light off now.ĭuring cold weather (15 F) engine revved (hunted) startup. I was told to replace oxygen sensor, which did no good, then I researched and found Mass Air Flow (MAF) sensor was to blame. They replaced that and cleaned the throttle body.Ĭheck engine light showed code P0171. The check engine light came on the car was idling really rough. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |